Rackmount Digital Gain Adjustable GNSS Repeater Kit | GNSSRK-M-RDV4
GPS and GNSS Repeater Kits
- BUY NOW
GNSSRK-M-RDV4 is a repeater operaters by receiving ful-band GNSS satelite signal with an antenna located outside the building and re-radiatig the signals into theindoor area or covered space where satellite signal cannot reach.
GNSSRK-M-RDV4 is a four point GPS/Glonass/Beidou2/Galleo repeaier, re-adiating GNSS signal. This solution ofier adjusiable test signal to receiver
if need extend the system, you can add assemblies and sending antennas. so as to cover satelite sional indoor aroe area and more rooms or buidinos
GNSSRK Serial Repeater Kit
- System signal：GPS/GLONASS/Beidou/Galileo/IRNSS/QZSS/SBAS/NAVIC/OmniStar
- Frequency range of the antenna:1556~1623MHz and 1164~1288 MHz;
- Frequency range of the amplifier:1164~1616 MHz;
- Gain digital display adjustable in steps
- Digital gain adjustment: 0-30dB, LED digital display；
- Serial command control；
- Input and output port power setting；
- Coverage Range:GNSSRK-M-RDV4: 4 antennas, each radiating 5-20 meters ；
The addition of the line amplifier GA40 to the front and end of the system can extend the radiation range.
For testing the cell- phone, PND, car navigators, tracker, survey products, etc.
2、For the purpose of GNSS signal covering
Car parks, lab, aviation manufacturing hangar, trade shows, Emergency-, safety vehicles, public transportation etc.
Equipment List With Standard Configuration
Amplifier: RGA30-DV ,1 ea;
GNSS Antenna: S440,1 ea;
Cable Assembly: RG8,30M, 1ea;
Cable Assembly: XHY240,20M,4 ea;
Cable Assembly: XHY240,5M,1 ea;
Sending Antenna: GRA10,4 ea;
Ligting-protector: 1 ea;
RF coaxial cable assembly can make more choices according to the actual needs of customers, please contact our company's sales for support.
Digital Display Step Adjustable Amplifier RGA30-DV
In ,Out, 50Ω
Digital Step Adjustable
12V DC Adaptor
Max RF Power
Nun. Of input
Nun. Of Output
Max RF Input
Maximum lossless RF input
GNSS repeater/GPS booster/GPS signal amplifier GNSSRK-M-RDV fault location and remove:
First: To determine whether the RGA30-DV power supply connected, through the RGA30-DV digital display can be observed to lose whether there is voltage output, such as digital display shows a voltage of about 5V, indicating normal power supply, RGA30-DV work properly. Otherwise, check the power outlet for good contact.
Second: If the digital stepper is adjustable, the input port of the amplifier has a voltage of 5V, you need to check whether the fixing is steady between GRA10 and the cable.
Third: If the below two step were ok, please check the outdoor antenna S440 .You can, check the voltage between axis of the cable connector and the outer shielding layer to make sure it’s 5V.If no voltage, the circuit has fault, please contact our technical support. If 5V,the antenna S440 can be suspected.(In fact, this case hasn’t appear in our engineering projects.
Contact us：+86-755-29644311 Email：Sales@gemsnav.com